Today I take a look at this 1967 Ford Bronco Sport and try to get it started but find out why it was put away in the first place.
This Week With Cars – Episode 0215 #BarnFind #FordBronco #BroncoSport
Today I take a look at this 1967 Ford Bronco Sport and try to get it started but find out why it was put away in the first place.
This Week With Cars – Episode 0215 #BarnFind #FordBronco #BroncoSport
Today I install a voltage regulator and fix the fuel system on Barn Sprite #6. See Part 1 with Barn Sprite #6 here: https://www.youtube.com/watch?v=Iv32Zob-0KU
This Week With Cars – Episode 0214 #BarnSprite #WillItRun #AustinHealey
Today I try to get a 1957 Pontiac Star Chief running after it has been sitting for over 10 years. Watch all my Pontiac videos here: https://youtube.com/playlist?list=PLRMQ-ShmnWOYkigIKPAOvCrS8504VdAeK
This Week With Cars – Episode 0208
#ClassicCars #Pontiac #Chieftain
Today I take a look at the barn find Sprite I labeled #4. I attempt to fix the clutch, brakes, and oil leak.
This Week With Cars – Episode 00139 #BarnSprite #AustinHealey #Sprite
Today I take a look at the barn find Sprite I labeled #4. I clean it out and see if I can get it started without any parts besides a battery.
Want a fuel drip bottle like I am using get one here: https://amzn.to/3v6aJNa
This Week With Cars – Episode 00132
#BarnSprite #AustinHealey #WillItRun
Kevin over at Junkyard Digs picked up this Datsun 280z but after sitting on it for a bit he called me up and asked if I wanted to tackle this car. I went and picked it up and brought it back to my shop to see if I could get it running.
Check out the Junkyard Digs video where this whole project got its start: https://youtu.be/XPLB3MqWRFE
This Week With Cars – Episode 0130
#Datsun #280Z #WillItRun
Today I attempt to get Barn Sprite #2 driving by cleaning the carburetors and putting in a new master cylinder and clutch slave cylinder.
Today I try to get a 1962 Austin Healey 3000 BT7 running that had been stored in a storage unit for many years. I end up finding more than I had bargained for.
Last round I found the starter that I was using needed rebuilt to be good enough to reliably turn the engine over. I now have the starter fix and installed and ready to see if the engine will now run.
Last round I found the engine was stuck and without a driveshaft I could not break the engine free. Today I install the missing driveshaft, deal with more surprise missing parts, and again see if the Sprite will run.